Sunday, May 30, 2010

That wasn't so hard

Except for those @ssholes at Brake Check rounding the head of one bolt holding the caliper assy. to the axle hub- which I broke my only 15mm hex socket on.
Thanks to the original multi-tool, I was able to work it out.

On a happy note, I found that the inner and outer bearings are the same- or close enough that I used the good inner bearing to replace the bad outer bearing and the inner with a new one.
It should last until the truck's paid off and I can afford to replace everything.

No comments:

Post a Comment

I've had to enable moderation because some bots just can't stop sh1tting where other people want to live......kind of like Liberals.

It's either this or WV...